One door hangs crooked, a drawer front is loose, and the sink base floor has gone soft. Cabinet repair in Jacksonville, FL is the smallest of the cabinet services we take on, and the one where we talk people out of spending money most often. Repair fixes function, not appearance. If your cabinets work and you dislike the color or door style, this is the wrong page.
Nearly every kitchen cabinet repair call here is one of these.
| Symptom | Real cause | Fix, and whether it lasts |
|---|---|---|
| Door swings open on its own | Worn Euro hinge | New hinge |
| Hinge screw spins | Stripped particleboard | Dowel and glue |
| Drawer drags or drops | Failed glide or bent track | New glides |
| Soft cabinet floor | Slow leak, swollen board | Replace the box |
The pattern matters: anything mechanical is a good repair, and anything where the material failed is a replacement decision.
Water damaged cabinets in Northeast Florida are almost never a flood. They are a supply line or a disposal gasket that wept a teaspoon a day for two years while the cabinet floor absorbed it.
Particleboard swells and does not come back. Once that floor is spongy the fibers are broken, and no drying, sealer or paint restores strength, so we replace the base. Painting over it, common on flipped houses in Arlington, hides the failure about a season. Plywood that dried without delaminating can often stay, and we cut in a new bottom panel.
One Jacksonville detail people miss: cabinets against a CBS block exterior wall can take on moisture through the wall if there is no furring gap, so we check the back panel too.
Cabinet door repair splits three ways. A crooked door is usually a hinge adjustment, since Euro cup hinges have three screws that move the door side to side, in and out, and up or down.
A split rail or a panel shrunk from its stile is a glue-up: pull the door, glue and clamp the joint, refit it. That works on solid wood, not MDF or thermofoil. A warped door we cannot save. Doors cup when one face takes on moisture the other did not, so a single replacement door is the answer.
The stripped hinge screw is the most common hardware failure we see, and the fix matters. A longer screw in blown-out particleboard grabs for a month. The right repair is to drill the hole out, glue in a hardwood dowel, and drill fresh pilots into solid wood. That joint ends up stronger than new.
Old face-frame hinges that sag are worth replacing outright, and that is the moment to move to soft close hinges or new pulls and knobs.
Cabinet box repair covers shelves, bottoms, backs and sides. Sagging shelves are the easy win: a 3/4 in particleboard shelf spanning 34 in under dishes bows, so we stiffen the front edge with hardwood or swap in plywood. Racked boxes and loose backs come from stapled construction giving up, and we pull the box square, glue and screw it, and add corner blocks.
Cabinet frame repair is the finest work here. A split stile or a joint opened at a corner gets repaired, not replaced, because you cannot swap a face frame without unbuilding the cabinet. We inject glue into the split, clamp it closed and pin it if the crack runs with the grain. Where wood is missing we let in a matching piece instead of epoxy, since filler reads as a patch under any finish.
| Situation | Repair | Replace | We recommend |
|---|---|---|---|
| One stripped hinge screw | $40 to $90 | n/a | Repair |
| One soft sink base | Not advisable | $450 to $900 | Replace the box |
| Three or more swollen bases | Not advisable | New cabinets | New cabinets |
| Doors worn, boxes solid | n/a | $2,500 to $6,500 | New doors |
| Finish worn, rest sound | n/a | $3,500 to $7,500 | Refinishing |
The line is simple. If the structure works and one part failed, repair it. If three or more boxes have failed, you are funding a new kitchen one repair at a time.
| Job | Typical range |
|---|---|
| Service call, kitchen wide adjustments | $150 to $350 |
| Hinge replacement, per door | $25 to $55 |
| Dowel and re-drill a stripped hinge | $40 to $90 each |
| Shelf stiffened or replaced | $60 to $150 each |
| Face frame split glued and touched up | $150 to $400 |
| One replacement base cabinet, installed | $450 to $900 |
Three things move the price: how many items we handle on one trip, whether finish touch-up is needed, and whether we are matching a stain. These are typical Jacksonville ranges and an exact number takes seeing the cabinets.
4.8 ★
Klein Carpentry holds a 4.8 star average across 51 Google reviews. Homeowners keep mentioning the same things: fast replies, crews who show up when they say they will, and attention to detail. Every cabinet repair project gets a written quote, a clear schedule and a daylight walkthrough at the end.
Humidity
Wood gains and loses moisture with the air around it, and the USDA Forest Products Laboratory's Wood Handbook shows how much it swells and shrinks as a result. We plan every cabinet repair job for that movement: stable sheet goods, acclimated lumber, moisture-resistant material near slabs and wet rooms, and joints with room to move.
3 Heights
Jacksonville homes range from plaster and concrete block to square new construction. We measure each opening at the floor, mid height and ceiling before building, then scribe the finished work to the wall. Depending on the piece, it is built in our shop and brought in finished or built on site in your home, so the fit stays tight either way.
4.8from 51 Google reviews
I am thrilled to share my positive experience with Ray and Klein Carpentry. From start to finish, they exceeded my expectations in every way possible. Their professionalism and commitment to quality were evident from the moment they arrived, and they consistently delivered exceptional work throughout the entire project. One of the standout aspects of working with Ray and Klein Carpentry was their ability to accommodate my needs and desires. They took the time to truly understand what I wanted and went above and beyond to ensure that I was completely satisfied with the end result. Their attention to detail was impeccable, and they demonstrated an unwavering commitment to ensuring that every aspect of the project was completed to the highest possible standards. Ray and Nathan were an absolute pleasure to work with - not only were they skilled craftsmen, but they were also kind, funny, and genuine individuals who truly cared about ensuring that I was happy with their work. They were punctual, reliable, and always went the extra mile to ensure that the project was completed on time and within budget. The end result of their work was simply stunning - a beautiful 20-foot built-in shelving unit with crown molding, complemented by a gorgeous accent wall behind the TV. The craftsmanship and attention to detail were second to none, and I have received countless compliments on their work from friends and family. Overall, I would not hesitate to recommend Ray and Klein Carpentry to anyone in need of their services. They are true professionals who take pride in their work and go above and beyond to ensure that their clients are completely satisfied. If you want exceptional quality and unparalleled customer service, look no further than Ray and Klein Carpentry - they truly are the best in the business.
Sam Scholten · 3 years ago on Google
Very happy with the professional work done by Klein Carpentry. We had wood accents done for the entrance way, great room and master bedroom. Fantastic craftsmanship and took the time to make it look perfect. Also had ceiling beams placed in the great room and master bedroom. They really complete both rooms. Lastly had wood accents for the half bath in the living area. Made a noticeable difference. Would highly recommend Klein Carpentry, highly detailed and professional.
Mike C · a month ago on Google
The level of quality Klein Carpentry has is next level. Their service is incredible and are very responsive and knowledgeable. They do all kinds of work. Highly recommend them for any projects you may have coming up!
Vladimir Orgunov · 4 months ago on Google
Reviews from Google
We do not recommend patching swollen particleboard, because the fibers have broken down and a patch fails again within a year or two. Replacing that one base runs about $450 to $900, matched to the rest of your run.
We can assess and repair, and we give you a written itemized scope to hand an adjuster. What we will not do is call a swollen box salvageable.
Often, but never perfectly. Old finishes amber with age, so a new part is a close blend at best, and on a visible run we may suggest refinishing that section.
Yes, and we usually change material while we are there. Unconditioned Jacksonville garages swing through big humidity changes, so we rebuild failed parts in plywood, not particleboard.
Usually the hinge screws are backing out of tired particleboard rather than the doors moving. Doweling and re-drilling those holes fixes it for good, where tightening screws lasts a few months.
For drawers that drag or drop
For doors warped past saving- [Cabinet refinishing](/services/cabinet-maker/cabinet-refinishing/) if the finish is the next problem
For built-in runs elsewhere in the house
From Klein Carpentry
Call (904) 759-4988 with what is failing, or send a photo. We cover Jacksonville and the towns around it and will tell you plainly whether your cabinets are worth repairing.
Get A Free Quote Today
